The methods to fix common-disorders of Raymond Mill are suggested in the following table:

Common Disorders 1 of Raymond Mill:

No powder-output or theamount below the capacity.

Reasons:

Powder-locking device is not sealed-up.

Shovels worn out.

HowToFix:

To check and make it sealed-up. To replace the worn shovels.

Common Disorders 2 of Raymond Mill:

Powder too rough or too fine.

Reasons:

Vanes worn out and can not function in separating Air flow is not fight.

HowToFix:

Replacethevanesandincreaseair-flowforfinerpowder.

Reduceairflowifpowderistoofine.

Common Disorders 3 of Raymond Mill:

The electric current and the heat of the main motor goes up, the current of the blower comes down.

Reasons:

Too much stuff fed, the folw channel blocked, pipes not working well etc.

HowToFix:

To adjust feeding amount, to clear-up the flow-channel, to reduce the moisture through the pipeline..

Common Disorders 4 of Raymond Mill:

Abnormalnoiseandtoomuchvibrationofthegrinde.

Reasons:

Too small amount of stuff fed, the grinder and transmission away from too hard material processed, rollers and rings distorted etc.

HowToFix:

Toadjusttheamountfed,toremedytheaway-from-coaxialtoreplacerollersandring.