The moisture content of the brewery yeast waste liquid reaches about 90%, the solid content is relatively low, and the material is in the form of mud, which can be dried with a yeast dryer for long-term storage. Because brewer's yeast is rich in nutrients, it is also a high-quality feed for the breeding industry.

Yeast dryer structure:

   Drying Cylinder--Frame--Transmission Device--Scraper Device--Limiting Device--Dipping Device--Hydraulic Jacking System--Electrical Control Cabinet--Steam Exhaust System

The working principle of yeast dryer:

   Yeast dryer is a dryer that heats materials and vaporizes water by indirect conduction heating, and uses steam to heat. The drying cylinder (drum) is a metal hollow cylinder with a processed outer surface and a very high surface finish. Driven by the transmission device (large and small gear transmission), the drying cylinder rotates around the axial direction and the speed can be adjusted. The slurry is preheated in the preheating tank, preheated to about 50 °C, and fed into the dipping tank at the lower part of the drying cylinder with a feeding pump, the drying cylinder is immersed for about 60-80mm, and the outer surface of the rotating drying cylinder is coated with a Layer uniform slurry (that is, film thickness), the steam pressure in the dryer is 0.15-0.3Mpa, the slurry is heated on the outer wall of the dryer, and the water is vaporized and discharged by the axial flow fan. When the drying cylinder rotates for one week, the material is dried, and the flake material is discharged by the scraper on the outer wall of the drying cylinder, and then falls to the discharge port for collection.

  If you have a large amount of spent brewer's yeast to process, please contact us.